Nitro rc car Support

Different frequencies
Most of the models we sell come with a little plug in them called a frequency crystal. To change the frequency you put a different plug into the controller ...
Fri, 4 Jul, 2014 at 6:42 AM
Car will not stay still
Usually this would mean you have the engine too lean or your carb is too open. Make sure your mixture screw is about 2mm below the top of the screw casing...
Fri, 4 Jul, 2014 at 6:43 AM
The spare wheel shafts I ordered for my model do not fit.
Sometimes people order the central drive shafts which go down the centre of the model. If you want the ones that go from the diff to the wheel these are dif...
Fri, 4 Jul, 2014 at 6:45 AM
Worn clutch bell
Clutch bells will not get worn unless there is a problem. For some reason the clutch shoes must not be able to rotate the bell easily so are just scraping...
Fri, 25 Jul, 2014 at 9:15 AM
Converting a condor into a 2 speed
You would need a 2 speed gearbox and a 2 speed clutch bell. 2 speed gearboxes are £25 and can be ordered on 01625 610031. The 2 speed clutch bell is code 3...
Fri, 4 Jul, 2014 at 6:46 AM
Priming an engine with fuel
The way to prime the engine is to put your finger over the exhaust hole and pull the starter. The engine pushes air out of the engine which usually goes o...
Fri, 4 Jul, 2014 at 6:47 AM
My nitro engine will not start anymore.
If your engine used to start and then when you came back to it one day it would not it could be that the engine needs cleaning or it could be that your glow...
Thu, 9 Oct, 2014 at 1:45 PM
Fuel spitting out of exhaust
That means it is a little rich but it is better to run it a bit rich if it is new as it is better for the engine. To lean it out you turn the mixture screw ...
Fri, 4 Jul, 2014 at 6:49 AM
How long does a bottle of fuel last?
You would be able to fill a 1/10th tank up 30 times from one bottle of fuel and each tank will last about 10 minutes.
Fri, 4 Jul, 2014 at 6:49 AM
Idle screw setup
Adjusting the idle screw does not actually adjust the idle speed, it adjusts how closed the carb can go. If you adjust it, yes the carb will be able to cl...
Fri, 4 Jul, 2014 at 6:50 AM