Support Portal

If your RC model is stalling while opening throttle than your engine is running too rich. Too much fuel is getting into the carburetor for the amount of air...

 I am sorry to hear you are unable to start your engine. An engine not starting is almost always down to technique or settings 1. If you have our he...

This happens when the engine is flooded and the engine is hydraulically locked. Pulling on the pullstarter while the engine is in this condition will break ...

. When you fully apply the brakes,the engine dies? the clutch springs has gone, this drags on the engine and stops it, also it will try and move as soon as ...

Your engine is running too lean. The engine runs hot and shuts off by itself because the piston has grown to large to be able to move up and down in the cyl...

This can be due to many things. The first thing that many new users of Nitro Cars need to know is that a Glow Plug Igniter is needed. The Glow Plug...

This is one of the most important things you need to do to protect the engine. An engine can wear out in under 10 minutes if the filter is not oiled. T...

If your model has the controls reversed (e.x. When the throttle is applied the steering functions, and when the steering is applied the throttle functions) ...

If your vehicle has the controls reversed (E.x. When the throttle is applied the model brakes instead, or when you steer left the model goes to the right) i...

If the engine is tuned properly you can let the engine run out of fuel or block the exhaust tip with a rag or your finger . put your thumb over the air inta...