Nitro rc car Support
Before using any nitro model it is important that you check the following:
* Receiver Battery * Range check (Stand a distance away from the model ...
Tue, 20 Jan, 2015 at 7:48 PM
1. Fill the fuel Tank and check that the fuel lines are secure and free of kinks to ensure clear fuel flow.
2. Prime the engine with fuel by putti...
Sat, 23 Aug, 2014 at 1:33 PM
The engine has to be Run-in before full-time use. It is very important that this procedure is carried out. Not doing so will shorten the life and reduce t...
Fri, 4 Jul, 2014 at 7:08 AM
It is VERY rare that a fault can be traced back to the engine. Check the following points below before considering the engine to be faulty.
1. Check...
Fri, 4 Jul, 2014 at 7:08 AM
If you have a 2 speed model the first gear in the gearbox (the bigger one) will have a one way bearing in the middle of it. This is a bearing that sits on...
Fri, 4 Jul, 2014 at 7:09 AM
The only way that a con rod can break is either the engine is revved with no load or there is not enough fuel in the engine so there is not enough lubricati...
Fri, 4 Jul, 2014 at 7:10 AM
If you are unable to pull the pull start without the wheels turning it means your clutch shoes have probably melted. This happens when the car has been inco...
Fri, 4 Jul, 2014 at 7:10 AM
The easiest way to learn that you have the correct gear mesh is to use a piece of paper and fit it between the spur gear and pinion gear as you tighten th...
Fri, 3 Oct, 2014 at 12:23 PM
Unless something is not adjusted properly or broken, the 2 speed should shift into second when the engine reaches a certain speed. If it does not shift, use...
Fri, 4 Jul, 2014 at 7:11 AM
No you do not. Just use common sense and do not use them where they may disturb or injure people if they loose control.
Sun, 31 Aug, 2014 at 5:05 PM