Support Portal

You can see a list of the main clubs at www.brca.org

The maintenance is easy but if done properly needs a little time and patience. Maintenance is really just cleaning, tightening screws and replacing damage...

If it has melted it means either you are running your engine to hot. To cool it down you need to adjust the mixture screw a little anti clockwise. There i...

For an Acme 1/10th model: With the radio equipment off please do the following 1. First of all open the carb so it is fully open. Look down int...

Insert batteries into transmitter and model. Do NOT have the engine running. 1, Install the failsafe unit between the receiver and throttle servo ( ...

All of our trucks and buggies are pretty good on road and off road. With use on sand though, we have used for hours on sand without any problems but if the ...

The glow start is used to ignite the engine when starting. You will always need one if you have one of our nitro models.

You can use any fuel between 10 and 30% although 10 - 16% is best for normal use and the higher ones are for racing as they are more expensive and put mor...

Do you have a budget? Basically if you are on a budget go for the Condor PRO which has a 2 speed gearbox but if you don't mind paying a bit more then th...

A failsafe is a small device that attaches to the receiver on your model. If the model goes out of range or loses the signal it will cut the power so it doe...