Nitro rc car Support

List of rc car clubs
You can see a list of the main clubs at
Wed, 1 Oct, 2014 at 9:04 AM
Is the maintenance of rc cars difficult?
The maintenance is easy but if done properly needs a little time and patience. Maintenance is really just cleaning, tightening screws and replacing damage...
Fri, 4 Jul, 2014 at 6:54 AM
Melted muffler / exhaust
If it has melted it means either you are running your engine to hot. To cool it down you need to adjust the mixture screw a little anti clockwise. There i...
Sun, 24 Aug, 2014 at 6:04 AM
Starting a nitro model
For an Acme 1/10th model: With the radio equipment off please do the following 1. First of all open the carb so it is fully open. Look down int...
Fri, 4 Jul, 2014 at 6:58 AM
How To Install A Failsafe
Insert batteries into transmitter and model. Do NOT have the engine running. 1, Install the failsafe unit between the receiver and throttle servo ( ...
Thu, 14 Aug, 2014 at 9:21 PM
Use on sand
All of our trucks and buggies are pretty good on road and off road. With use on sand though, we have used for hours on sand without any problems but if the ...
Fri, 4 Jul, 2014 at 7:02 AM
What is a glow starter for and do I need one?
The glow start is used to ignite the engine when starting. You will always need one if you have one of our nitro models.
Fri, 4 Jul, 2014 at 7:03 AM
What percentage fuel to use and what kind
You can use any fuel between 10 and 30% although 10 - 16% is best for normal use and the higher ones are for racing as they are more expensive and put mor...
Fri, 4 Jul, 2014 at 7:03 AM
Which nitro model would you recommend?
Do you have a budget? Basically if you are on a budget go for the Condor PRO which has a 2 speed gearbox but if you don't mind paying a bit more then t...
Fri, 4 Jul, 2014 at 7:04 AM
What is a failsafe?
A failsafe is a small device that attaches to the receiver on your model. If the model goes out of range or loses the signal it will cut the power so it doe...
Fri, 4 Jul, 2014 at 7:04 AM